i had the same issues and i took copper tape and wrapped the usb cable, power cable, the bundle going into the control box, the inside of the control box, i ran my router power cord opposite of the control box and it doesnt touch the cnc frame. The tutorial starts with the introduction of high frequency high voltage power supply including the basics, development history, the state-of-the-art technologies and future technology trends. Clicking on any of the 9 points shown on the table will move your machine to the position that was clicked. Click the ‘Connect Cutter’ Icon in the center of the window to connect to your machine. It was initially added to our database on 01/25/2017. I attempted to run the project, and the pen went way up in the air about 2" and to the lower left of … Withdraw. Originally licensed for use only with the ShapeOko 3 and Nomad 883, it is now available for anyone to use. Alex (Alex Thevenot) August 16, 2016, 4:37pm #6. ... A detailed instruction tutorial on using inkscape is located here: Inkscape Laser Plug-In. Design your projects and create toolpaths with Carbide Create, then export the gcode and load it into Carbide Motion to turn your digital project into a virtual creation.